Name

slaptest — Check the suitability of the OpenLDAP slapd.conf file

Synopsis

SBINDIR/slaptest [ −d level ] [ −f slapd.conf ] [ −F confdir ] [ −o name[=value] ] [−Q] [−u] [−v]

DESCRIPTION

Slaptest is used to check the conformance of the slapd.conf(5) configuration file. It opens the slapd.conf(5) configuration file, and parses it according to the general and the backend-specific rules, checking its sanity.

OPTIONS

−d level

enable debugging messages as defined by the specified level; see slapd(8) for details.

−f slapd.conf

specify an alternative slapd.conf(5) file.

−F confdir

specify a config directory. If both −f and −F are specified, the config file will be read and converted to config directory format and written to the specified directory. If neither option is specified, slaptest will attempt to read the default config directory before trying to use the default config file. If a valid config directory exists then the default config file is ignored. If dryrun mode is also specified, no conversion will occur.

−o option[=value]

Specify an option with a(n optional) value. Possible generic options/values are:

              syslog=<subsystems>  (see `−s' in slapd(8))
              syslog-level=<level> (see `−S' in slapd(8))
              syslog-user=<user>   (see `−l' in slapd(8))
−Q

Be extremely quiet: only the exit code indicates success (0) or not (any other value).

−u

enable dryrun mode (i.e. don't fail if databases cannot be opened, but config is fine).

−v

enable verbose mode.

EXAMPLES

To check a slapd.conf(5) give the command:

        SBINDIR/slaptest -f /ETCDIR/slapd.conf -v

SEE ALSO

ldap(3), slapd(8) slapdn(8)

"OpenLDAP Administrator's Guide" (http://www.OpenLDAP.org/doc/admin/)

ACKNOWLEDGEMENTS

OpenLDAP Software is developed and maintained by The OpenLDAP Project <http://www.openldap.org/>. OpenLDAP Software is derived from University of Michigan LDAP 3.3 Release.


See the following documents: COPYRIGHTLICENSE